After Daily Use

After Daily Use

End-of-work procedure

1. Perform daily maintenance.

2. Exit Cleaning mode.

3. Turn this device off.

When Not Using for an Extended Period of Time

1. After cleaning all parts, turn off the power breaker.

2. Drain the water from the rinse tank.

   Draining the Water from the Rinse Tank

3. When resuming use, prepare the device for operation.

   Restarting the Device After Not Using It for a Long Period of Time

Draining the Water from the Rinse Tank

1. Close the water supply valve.

   * For information about the water supply valve, please contact the installer.

2. Lift the front cover (right side) slightly upwards and remove it.

   

3. Remove the two screws holding the front cover (left side).

   

4. Open the front cover (left side).

   

5. Turn the drain valve in front of the rinse tank to the left until it is in the horizontal position (open).

   The water will drain from the rinse tank.

   

6. Once the water in the rinse tank has completely drained, turn the drain valve to the right to return it to the vertical position (closed).

   

Restarting the Device After Not Using It for a Long Period of Time

If the device has not been used for an extended period of time, the water remaining in the rinse tank may have spoiled.
When resuming use after not using the device for a long period of time, follow the steps below before starting operation.

1. After preparing the device for operation, leave it in standby state for at least 30 minutes to sterilize it with heated rinse water.

2. Then, perform manual cleaning two to three times.